SECTION 27 - REAR AXLE 71
Press the bearing (7).
Support the differential assy (2) with a rod and as-
semble it.
Fit the outer cups of the bearings (7) by means of
the special tool 380002671 and a hammer.
Insert and tighten the ring nuts (6), using the wrench
380002218 until the clearance of the bearings is re-
moved.
NOTE: tighten the ring nuts gradually but not exces-
sively.
Assemble the ring nut retainer (5) and fasten it by
means of the screw (4).
7
F28069
F28070
2
F28071
7
F28072
6
4 5
To Next Page
Loading...
