CHC i80 User Manual

3. Front panel operation
i80 GNSS Receiver User Guide  Page 33
Working Mode
Menus in Configuration Screen
Description
Ntrip.
 Click Enter button to enter the
configuration screen.
Mode Rover Ntrip/IP
The title of this configuration screen.
Status Logged
 Indicates current status of Ntrip: Status Not
Logged or Status Logged.
 Users need to use the web interface to
configure the settings to log on Ntrip (see
7.5.1. IO Settings submenu → RTK Client for
instruction) before.
Note – Make sure a valid SIM card has been
inserted in the receiver.
OK
Click Enter button to save the settings and back
to the top-level menu, and then this working
mode will take effect.
Cancel
Click Enter button to cancel the settings and back
to the second-level menu.
Rover UHF
 Set up the receiver as a rover station using
internal UHF.
 Click Enter button to enter the
configuration screen.
Mode Rover UHF
The title of this configuration screen.
Channel 1
Click Enter button to change the channel from 1
to 9.
Protocol CHC
Indicates the current protocol.
OK
Click Enter button to save the settings and back
to the top-level menu, and then this working
mode will take effect.
Cancel
Click Enter button to cancel the settings and back
to the second-level menu.
Note – The operation menus of front panel may vary from different firmware
versions of your receiver. The menus described in this chapter are based on
firmware version 1.1.16.

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English