Local Operation
In the page of Advance function, turn the Rotary knob to change the display value to 4, then
press key into the page of Program Sequences Function, the VFD displays Program
Sequences Function.
[ AUTO SEQUENCES ]
0 . 0 0 0 0 V
0 . 0 0 0 0 A
Press the key to enter into the editing mode. Then, press to select the
setting parameter.
1. Setting the Number of Program.
There are ten programs (1-10) and up to 100 sequences can be set. Turn the Rotary
knob to change the display value to 1, then press key to confirm the setting.
PROG: 01
2. Setting Type of program.
There are two types of program: List and Step. Turn the Rotary knob to change the type
until the desired type is displayed on the VFD. Then, press key to select type
and confirm the setting.
TYPE: LIST
3. Setting the Program Chain
The chain function of program enables you to chain program so as to get more
sequences for testing. Set program chain number to 0 means no program chain.
Program chain function can chain itself for loop test, or chain other programs. Turn the
Rotary knob to change the display value to 1, then press to set chain itself for
loop test. The default setting is 0.
CHAIN: 1
4. Set Repeat Times.
Set the repeat times of the Program Chain. Turn the LOAD Rotary to change the
Repeat times as desired. Then, press key to confirm the setting.
REPEAT: 1
5. Display the Remain Unsetting Sequence Amount.
The Load shows the Remain Unsetting Sequence amount, which is from total 100
Sequences subtracting the amount of the total setting Sequences.
To Next Page
Loading...
Need help?
General
