6-7
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 6 Installing the Router
Basic Hardware Installation
Figure 6-5 AC Connector Notch
Power and Reset Buttons
There are two reset buttons inside the router chassis. See Figure 3-15 for button locations. These buttons
are used to reset the router power and software configuration. They are not used to power the router on
and off; the router powers on immediately when it is connected to an AC power source.
Caution When you use the CONFIG Reset button to restore the router to the factory default software
configuration, the current software configuration is permanently deleted from the router.
• CONFIG Reset—Press the CONFIG Reset button for at least 5 seconds to return the router
software configuration to the factory default, and power cycle the router. Power cycling the router
turns the router off, then immediately back on. The router will temporarily stop operating on the
network during the power cycle, then resume operating when the power cycle process is complete.
• PWR RESET—Press the PWR RESET button for at least 5 seconds to power cycle the router.
Power cycling the router turns the router off, then immediately back on. The router will temporarily
stop operating on the network during the power cycle, then resume operating when power cycle
process is complete.
The topics in this section include:
• Accessing the Buttons, page 6-8
• Related Information, page 6-8
Item Description
1 AC connector notch
300589
1
To Next Page
Loading...
