5-10
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
Step 9 Use a socket wrench to evenly tighten all four carriage bolts to finish installing the mounting plate on
the pole.
Figure 5-7 Mounting Plate Installed on Pole with Clamp Brackets
Install the Mounting Plate—Poles Larger than 4.5 Inches in Diameter
To install the mounting plate on a vertical pole that is larger than 4.5 inches (11.4 cm) in diameter, follow
these steps and refer to Figure 5-8.
What you need
• Mounting plate and steel straps included in the “Pole Mount Kit” section on page 5-2.
• BAND-IT tool included in the “Strap Tool Kit” section on page 5-6
• Torque wrench
Item Description
1 Pole clamp notch
2 Carriage bolts (4)
3 Pole clamps (2)
300608
1
2
3
To Next Page
Loading...
