13-9
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 13 Installing External Non-Cisco Modules
Install an External Non-Cisco Module
Figure 13-3 Router Ethernet Ports
Connect to Power
Note About Power over Ethernet (PoE)
If the module is connected to a PoE port on the router, you do not have to follow the steps in this section
because the module is powered over Ethernet cable that you connected by following the steps in the
“Connect to the Network” section on page 13-8.
Note About Module Power Connector
Depending on your module power cable, you might need to provide an adapter to connect the module to
a 4-pin Micro-Fit 3.0 power connector. For detailed information about this connector, see the
“Non-Cisco Module Power Connector” section on page B-4 in the “Connector and Cable Specifications”
appendix.
To Next Page
Loading...
