6-3
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 6 Installing the Router
Basic Hardware Installation
Connect to the Ethernet Backhaul Network
The available Ethernet connection must meet the requirements described in the “Installation Safety and
Site Preparation” chapter.
Note The external connector described in this section is connected to one of the Ethernet ports inside the
router chassis. The internal port used depends on the router hardware configuration. If you are
connecting the external Ethernet connector to an internal Ethernet port for the first time, Cisco
recommends you connect it to the ETH 2/5 port.
Step 1 Remove the cover from the external Ethernet connector.
Step 2 Connect the local Ethernet cable to the router exterior Ethernet connector on the base of the router
(Figure 6-1).
Step 3 Tighten the cable coupling ring (shown in Figure 6-2) over the exterior router Ethernet connector to
ensure an adequate seal over the connector.
Figure 6-1 External Ethernet Connector
Item Description
1 External Ethernet connector
300587
1
To Next Page
Loading...
