11-6
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 11 Using the SD Flash Memory Module
Related Commands
• sd-card password, page 11-6
• no sd-card password, page 11-6
• show sd-card password status, page 11-6
copy running-config startup-config
To save the router current software configuration to the SD card, use the copy running-config
startup-config command in user EXEC mode:
cgr1240# copy running-config startup-config
[########################################] 100%
Copy complete, now saving to disk (please wait)...
sd-card password
To set a password for the SD card, use the sd-card password password command in global configuration
mode.
cgr1240(config)# sd-card password password
no sd-card password
To remove the SD card password, use the no sd-card password command in global configuration mode.
cgr1240(config)# no sd-card password
show sd-card password status
To determine the status of the SD card password, use the show sd-card password status command in
user EXEC mode.
cgr1240# show sd-card password status
To Next Page
Loading...
