Cisco 1240 - SD Card Slot Access for Bracket-Mounted Routers

5-25
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
Step 5 Install the four mounting bolts through the bracket and into the wall. Secure properly by hand-tightening
in a star pattern order. Beginning with the first bolt, tighten using the wrench. Torque based on hardware
and wall material. Torque center bolt last.
Step 6 Install the router onto the mounting bracket. See the “Install the Router onto the Mounting Bracket”
section on page 5-16.
Step 7 Install the optional security panel. See the “Install the Optional Security Panel” section on page 5-19.
SD Card Slot Access for Bracket-Mounted Routers
When the Cisco mounting bracket is attached the router according to the instructions in this chapter, the
bracket blocks access to the SD card port slot the router exterior.
Note You must open or remove the mounting bracket security panel to see or access the SD card port.
To access the SD card slot (
1) without removing the router from the bracket or any mounting installation
that uses the bracket, follow these steps and refer to Figure 5-22:
Step 1 One one side of the router, remove the three bolts shown in Figure 5-15.
Step 2 Loosen but do not remove the fourth bolt that is inserted in the quick hang slot.
Step 3 Repeat Step 1 through Step 2 on the other side of the router.
Step 4 Tilt the bracket on the quick mount slot, as shown in Figure 5-22.
Caution Be sure to reinstall and tighten all eight bolts with 6-7 foot-pounds of torque when you finish using the
SD card slot. The router must be securely attached to the mounting bracket with four bolts on each side.