Cisco 1240 - Strap Tool Kit

5-6
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Contents of the Mounting Kits
Strap Tool Kit
When to Use
Use the tool in the Strap Tool Kit to attach the steel straps included in the band strap kit. Steel straps are
required to install the mounting plate on poles larger than 4.5 inches (11.4 cm) in diameter. For more
information, see the “Band Strap Kit” section on page 5-5.
Note The tool in the Strap Tool Kit is manufactured and supported by BAND-IT. For more information about
the tool, see www.band-it-idex.com.
Figure 5-4 Strap Tool Kit Contents
Item Description
1 Strap tool
2 Strap tool documentation (not shown)
1
300605