5-14
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
The instructions for the procedures in this section refer to the mounting plate features shown in
Figure 5-11.
Figure 5-11 Mounting Bracket Details
To attach the mounting bracket to the mounting plate, follow these steps and refer to Figure 5-12. The
mounting plate must be installed according to the instructions in the “Install the Mounting Plate onto a
Pole” section on page 5-8.
What You Need
• Mounting bracket and hardware included in the the “Mounting Bracket Kit” section on page 5-4
• 13-mm box-end socket wrench
Step 1 Assemble four sets of bracket hardware (washer, split lock washer, and bolt) as shown in the “Assemble
Bracket Hardware” section on page 5-13.
Step 2 Place the mounting bracket against the mounting plate by inserting the bracket quick hang notch over
the mounting plate quick hang stud (
4).
Step 3 Thread the serrated nut onto the quick mount stud (4) and hand tighten (do not overtighten).
Step 4 Align the pivot grooves (2) on the bracket with four of the bracket mount holes (1) on the mounting plate.
Follow these guidelines:
• Each of the four pivot grooves on the bracket must be attached to at least one bracket mount hole on
the mounting plate.
• The final desired orientation of the mounting plate and router determine which bracket mount holes
are used.
Item Description
1 Pivot grooves (4)
2 Quick hang notch
3 Quick hang slots (2)
4 Optional wall-mount holes (4)
300612
1
4
3
2
To Next Page
Loading...
