Cisco 1240 - Attach the Mounting Bracket to the Mounting Plate; Assemble Bracket Hardware

5-13
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
Attach the Mounting Bracket to the Mounting Plate
This section describes how to attach the mounting bracket to the mounting plate.
Assemble Bracket Hardware
Several of the procedures in this section require you to assemble the bracket hardware before installing
the bracket. A bracket hardware set consists of one bolt, one washer, one split lock washer, and one nut.
To assemble the bracket hardware, follow these steps:
Step 1 Slide the split lock washer (2) on the bolt (1).
Step 2 Slide the regular washer (3) on the bolt (1).
The split lock washer should be between the regular washer and the bolt as shown in Figure 5-10.
Figure 5-10 Assemble Bracket Hardware Sets
300611
1
2
3