5-8
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
Install the Mounting Plate onto a Pole
This section describes three different procedures for installing the mounting plate on a pole. Follow the
instructions for the pole type used in your installation.
The instructions in these section refer to the mounting plate features shown in Figure 5-5.
• Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter, page 5-8
• Install the Mounting Plate—Poles Larger than 4.5 Inches in Diameter, page 5-10
• Install the Mounting Plate—Through-Pole Mounting (Optional), page 5-11
Figure 5-5 Mounting Plate Details
Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter
To install the mounting plate on a vertical pole up to 4.5 inches (11.4 cm) in diameter, follow these steps
and refer to Figure 5-6 and Figure 5-7.
Item Description Qty.
1 Carriage bolt holes 4
2 Bracket mount holes 8
3 Clearance holes, 3/4 in. 2
4 Pole clamp notches 2
5 Steel band strap slots 4
300606
1
5
4
4
2
3
Reverse angle
To Next Page
Loading...
