8-3
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 8 Unmounting the Router
Transporting the Router
Step 8 Remove 3 of the 4 bolts that attach the mounting bracket to the router. Do not remove the hinge bolt,
which is the fourth bolt. Remove the equivalent bolts on the opposite side of the router.
Figure 8-2 Removing Bolts from Security Bracket
Step 9
Loosen hinge bolts two complete turns (do not loosen so that the bolts are removed from chassis).
Step 10 Remove the router from the bracket.
Transporting the Router
This section includes instructions on transporting the router after it has been unmounted.
Step 1 Disconnect lightning arrestors that might be installed on the router.
Step 2 Verify that all open chassis ports are sealed with the cable port seal plugs shipped with the router.
300616
To Next Page
Loading...
