Cisco 1240 - Related Commands; CG-OS Battery Backup Commands; Backup-Battery Firmware Upgrade; Show Environment Power

12-23
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 12 Installing Battery Backup Units
Related Commands
Related Commands
• CG-OS Battery Backup Commands, page 12-23
• Cisco IOS Battery Backup Commands, page 12-27
CG-OS Battery Backup Commands
This section describes the battery backup commands for routers using the Cisco CG-OS operating
system, including:
• backup-battery firmware upgrade, page 12-23
• show environment power, page 12-23
• backup-battery enable, page 12-24
• backup-battery disable, page 12-24
• backup-battery reset, page 12-25
• backup-battery hard-reset, page 12-25
• backup-battery inhibit discharge, page 12-25
• poweroff module number backup-battery, page 12-26
backup-battery firmware upgrade
Note The backup-battery firmware upgrade command only works on routers using the Cisco CG-OS
operating system.
To upgrade the BBU firmware, use the backup-battery firmware upgrade EXEC command in user
EXEC mode:
CGR1240# backup-battery firmware upgrade
When this command is issued, the firmware upgrade is executed in the background and a syslog message
is displayed when the upgrade is complete.
To view the status of the BBU firmware download during the upgrade process, use the show
environment power EXEC command in user EXEC mode. For more information, see the “show
environment power” section on page 12-23.
show environment power
Note The show environment power command only displays both the power statistical data and the battery
backup status on routers using the Cisco CG-OS operating system. The command only displays the
power statistical data on routers using the Cisco IOS operating system.
To display the power statistical data and battery backup status, use the show environment power
command in user EXEC mode:
CGR1240# show environment power