5-24
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
What You Need
• Mounting bracket. For bracket dimensions, see Figure 5-20 on page 5-23 and Figure 5-21 on
page 5-24.
• Socket wrench that you supply
• 5/16th-in. or M8 bolts or equivalent (5) (customer supplied)
• Bolt reinforcement hardware (for example, wall shoe anchor bolts) (5) (customer supplied)
Step 1 Place the mounting bracket onto the location on the wall. Mark the locations of the four mounting holes
and the one center hole.
Step 2 (If Required) Install the bolt reinforcement hardware onto the wall at the five hole locations.
Step 3 Install the bolt into the center hole location. Do not fully thread in; leave bolt extended about 1/4”.
Step 4 Align the center hole of the mounting bracket over the previously installed bolt so that the bracket rests
on the bolt.
Figure 5-21 Securing the Wall-mount Bracket to the Wall
Item Description
1 Bracket: bolt holes (4)
2 Customer-supplied hardware: 5/16th-in. or M8 bolts or equivalent (1)
3 Mounting bracket (1)
4 Center mounting hole (1)
5 Customer-supplied hardware: 5/16th-in. or M8 bolds or equivalent (4) (same as #2 above)
To Next Page
Loading...
