Cisco 1240 - Page 177

12-29
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 12 Installing Battery Backup Units
Related Commands
To display battery data information, use the show platform battery command in user EXEC mode. The
command syntax is:
show platform battery [brief | cable | details | short | sprom | unit]
Syntax Description:
The following are examples of the command, with sample output:
CGR1240# show platform battery
Battery is not present
Battery pack state: Not available
The command output indicates a battery is not present.
CGR1240# show platform battery brief
Battery level 92% (12:27), Idle
The command output indicates that the battery is charged to a 92% level, has q2 hours and 27 minutes
battery life available, and is in an idle state.
CGR1240# show platform battery cable
Status register 0x16
brief (Optional) Displays summary information about the battery charge level in
percentage and hours:minutes formats, as well as the battery charge state:
• Idle, if > 85%
• Charging, if voltage > 10.5 V and charge value < 85%.
• Discharging, if battery is main source of power.
• Empty, if battery is drained out of charge.
cable (Optional) Displays details about the battery cable status:
• present = 0, in the command output means that a battery cable is not
present.
• present = 1, in the command output means that a battery cable is
present.
details (Optional) Displays troubleshooting information about the battery by
presenting a range of summary information about the battery
characteristics.
short (Optional) Displays backup battery information in short format (formatted
for a management device).
sprom (Optional) Displays troubleshooting information based on the eeprom
details of the battery unit.
unit (Optional) Displays a range of battery charge, capacity, and parameter
information including:
• battery charge state and charge value/level in percent.
• capacity (remaining and full charge).
• voltage and current levels.
• firmware version details.