Cisco 7925G - Unified Wireless IP Phone VoIP - Page 153

7-9
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 7 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Phone
Forced
authorization
codes (FAC)
Controls the types of calls that certain users can place. For more information, refer to Cisco
Unified
Communications Manager
Features and Services Guide, “Client
Matter Codes and Forced Authorization
Codes” chapter.
Group call pickup Allows a user to answer a call ringing on a phone in another
group by using a group pickup code.
For more information, refer to Cisco
Unified Communications Manager
Features and Services Guide, “Call Pickup
Group Configuration” chapter.
Hold Allows users to move connected calls from an active state
to a held state.
Requires no configuration, unless you want
to use music on hold; see
Music on hold,
page 7-11.
Hold Reversion Limits the amount of time that a call can be on hold before
reverting back to the phone that put the call on hold and
alerting the user.
Reverting calls are distinguished from incoming calls by a
single ring (or beep, depending on the new call indicator
setting for the line). This notification repeats at intervals if
not resumed.
A call that triggers Hold Reversion displays a brief
message on the status line.
You can configure call focus priority to favor incoming or
reverting calls.
For more information about configuring
this feature, refer to Cisco Unified
CallManager Features and Services
Guide, “Hold Reversion” chapter.
Hunt group Provides load sharing for calls to a main directory number.
A hunt group contains a series of directory numbers that
can answer the incoming calls. When the first directory
number in the hunt group is busy, the system hunts in a
predetermined sequence for the next available directory
number in the group and directs the call to that phone.
For more information, refer to:
• Cisco Unified Communications
Manager Administration Guide, “Hunt
Group Configuration” chapter.
• Cisco Unified Communications
Manager System Guide,
“Understanding Route Plans” chapter.
Immediate Divert Allows a user to transfer a ringing, connected, or held call
directly to a voice-messaging system.When a call is
diverted, the line becomes available to make or receive new
calls.
For more information, refer to:
• Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phones” chapter.
• Cisco Unified Communications
Manager Features and Services
Guide, “Call Park and Directed Call
Park” chapter
Table 7-1 Telephony Features for the Cisco Unified Wireless IP Phone 7925G (continued)
Feature Description Configuration Reference