Cisco Catalyst 2950 User Manual

Contents
xxv
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-12
Preparing to Download or Upload a Configuration File By Using RCP B-16
Downloading a Configuration File By Using RCP B-17
Uploading a Configuration File By Using RCP B-18
Clearing Configuration Information B-19
Clearing the Startup Configuration File B-19
Deleting a Stored Configuration File B-19
Working with Software Images B-19
Image Location on the Switch B-20
tar File Format of Images on a Server or Cisco.com B-20
Copying Image Files By Using TFTP B-21
Preparing to Download or Upload an Image File By Using TFTP B-22
Downloading an Image File By Using TFTP B-22
Uploading an Image File By Using TFTP B-24
Copying Image Files By Using FTP B-24
Preparing to Download or Upload an Image File By Using FTP B-25
Downloading an Image File By Using FTP B-26
Uploading an Image File By Using FTP B-27
Copying Image Files By Using RCP B-28
Preparing to Download or Upload an Image File By Using RCP B-29
Downloading an Image File By Using RCP B-30
Uploading an Image File By Using RCP B-32
I NDEX

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz