Index
IN-23
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-12
received traffic 24-3
reflector port 24-5
session limits 24-7
sessions
creating
24-13
defined 24-3
removing source (monitored) ports 24-16
specifying monitored ports 24-13
source ports 24-4
transmitted traffic 24-3
RSTP
active topology, determining
14-6
BPDU
format
14-9
processing 14-10
designated port, defined 14-6
designated switch, defined 14-6
interoperability with IEEE 802.1D
described
14-5
restarting migration process 14-22
topology changes 14-10
overview 14-6
port roles
described
14-6
synchronized 14-8
proposal-agreement handshake process 14-7
rapid convergence
described
14-7
edge ports and Port Fast 14-7
point-to-point links 14-7, 14-22
root ports 14-7
root port, defined 14-6
See also MSTP
running configuration, saving
4-11
S
scheduled reloads 4-16
secure ports, configuring 21-6
secure remote connections 8-33
Secure Shell
See SSH
security, port
21-6
sequence numbers in log messages 26-8
sequences, LRE
global, assigning
12-13
specific port, assigning 12-14
sequences, table of 12-5, 12-6
server mode, VTP 17-3
servers, BOOTP 1-4
service-provider network, MSTP and RSTP 14-1
set-request operation 27-5
settings
duplex mode
12-11
speed 12-11
set-top box, television 1-17, 1-20
setup program, failed command switch
replacement
31-10, 31-12
severity levels, defining in system messages 26-8
show alarm commands 3-6, 3-9, 3-10, 3-11
show and more command output, filtering 2-9
show cdp traffic command 23-5
show cluster members command 6-4
show configuration command 10-15
show controllers ethernet-controller command 12-7
show controllers lre profile commands 12-12, 12-13, 12-16,
12-19
show controllers lre profile mapping 3-7
show controllers lre status commands 12-11, 12-13, 12-14,
12-21, 12-22
show interfaces command 10-12, 10-15
show running-config command
displaying ACLs
28-18, 28-19, 28-20
interface description in 10-15
shutdown command on interfaces 10-17
signal to noise ratio 12-16
Simple Network Management Protocol
See SNMP