Cisco Catalyst 2950 - Page 667

Index
IN-25
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-12
sessions
creating
24-8
defined 24-3
removing destination (monitoring) ports 24-11
removing source (monitored) ports 24-11
specifying monitored ports 24-8
source ports 24-4
transmitted traffic 24-3
spanning tree and native VLANs 16-16
Spanning Tree Protocol
See STP
speed
configuring on interfaces
10-10
setting on CPE devices 12-11
SSH
configuring
8-34
cryptographic software image 8-33
described 8-33
encryption methods 8-33
user authentication methods, supported 8-34
Stack Membership Discovery Protocol 15-6
standby command switch, requirements 6-2
startup configuration
booting
manually
4-13
specific image 4-13
clearing B-19
configuration file
automatically downloading
4-12
specifying the filename 4-12
default boot configuration 4-12
static access ports
assigning to VLAN
16-11
defined 10-2, 16-3
static addresses
See addresses
static VLAN membership
16-2
statistics
CDP
23-5
IEEE 802.1x 9-25
interface 10-16
QoS ingress and egress 29-39
RMON group Ethernet 25-6
RMON group history 25-5
SNMP input and output 27-16
VTP 17-16
sticky learning
configuration file
21-7
defined 21-7
disabling 21-7
enabling 21-7
saving addresses 21-7
storm control
configuring
21-2
default configuration 21-2
described 21-1
disabling 21-3
displaying 21-13
STP
accelerating root port selection
15-4
BackboneFast
described
15-9
enabling 15-19
BPDU filtering
described
15-3
enabling 15-16
BPDU guard
described
15-2
enabling 15-15
BPDU message exchange 13-2
configuration guidelines 13-12, 15-14
configuring
forward-delay time
13-22
hello time 13-21
in cascaded stack 13-23
maximum aging time 13-22