Contents
vii
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-12
Configuring NTP Authentication 7-4
Configuring NTP Associations 7-5
Configuring NTP Broadcast Service 7-6
Configuring NTP Access Restrictions 7-8
Configuring the Source IP Address for NTP Packets 7-10
Displaying the NTP Configuration 7-11
Configuring Time and Date Manually 7-11
Setting the System Clock 7-11
Displaying the Time and Date Configuration 7-12
Configuring the Time Zone 7-12
Configuring Summer Time (Daylight Saving Time) 7-13
Configuring a System Name and Prompt 7-14
Default System Name and Prompt Configuration 7-15
Configuring a System Name 7-15
Understanding DNS 7-15
Default DNS Configuration 7-16
Setting Up DNS 7-16
Displaying the DNS Configuration 7-17
Creating a Banner 7-17
Default Banner Configuration 7-17
Configuring a Message-of-the-Day Login Banner 7-18
Configuring a Login Banner 7-19
Managing the MAC Address Table 7-19
Building the Address Table 7-20
MAC Addresses and VLANs 7-20
Default MAC Address Table Configuration 7-21
Changing the Address Aging Time 7-21
Removing Dynamic Address Entries 7-21
Configuring MAC Address Notification Traps 7-22
Adding and Removing Static Address Entries 7-24
Configuring Unicast MAC Address Filtering 7-25
Displaying Address Table Entries 7-26
Managing the ARP Table 7-26
CHAPTER
8 Configuring Switch-Based Authentication 8-1
Preventing Unauthorized Access to Your Switch 8-1
Protecting Access to Privileged EXEC Commands 8-2
Default Password and Privilege Level Configuration 8-2
Setting or Changing a Static Enable Password 8-3
To Next Page
Loading...
