8-6
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
Chapter 8 Configuring SDM Templates
.Displaying the SDM Templates
.Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | dual-ipv4-and-ipv6 default | lanbase-routing | qos] privileged
EXEC command to display the resource numbers supported by the specified template.
Note The Catalyst 2960-S switch supports only the default and lanbase-routing templates. The Catalyst
2960-C Gigabit Ethernet switch supports only a default template.
This is an example of output from the show sdm prefer command, displaying the template in use.
Switch# show sdm prefer
The current template is "lanbase-routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 255 VLANs.
number of unicast mac addresses: 4K
number of IPv4 IGMP groups + multicast routes: 0.25K
number of IPv4 unicast routes: 0.75K
number of directly-connected IPv4 hosts: 0.75K
number of indirect IPv4 routes: 1K
number of IPv4 policy based routing aces: 0
number of IPv4/MAC qos aces: 0.125k
number of IPv4/MAC security aces: 0.375k
To Next Page
Loading...
