Cisco CATALYST 2960

33-65
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
Chapter 33 Configuring QoS
Configuring Standard QoS
Configuring DSCP Maps
These sections contain this configuration information:
• Configuring the CoS-to-DSCP Map, page 33-65 (optional)
• Configuring the IP-Precedence-to-DSCP Map, page 33-66 (optional)
• Configuring the Policed-DSCP Map, page 33-67 (optional, unless the null settings in the map are
not appropriate)
• Configuring the DSCP-to-CoS Map, page 33-68 (optional)
• Configuring the DSCP-to-DSCP-Mutation Map, page 33-69 (optional, unless the null settings in the
map are not appropriate)
All the maps, except the DSCP-to-DSCP-mutation map, are globally defined and are applied to all ports.
Configuring the CoS-to-DSCP Map
You use the CoS-to-DSCP map to map CoS values in incoming packets to a DSCP value that QoS uses
internally to represent the priority of the traffic.
Table 33-13 shows the default CoS-to-DSCP map.
If these values are not appropriate for your network, you need to modify them.
Table 33-13 Default CoS-to-DSCP Map
CoS Value DSCP Value
00
18
216
324
432
540
648
756