1-19
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
Chapter 1 Overview
Network Configuration Examples
–
No secure ports are configured. For more information, see Chapter 23, “Configuring Port-Based
Traffic Control.”
• CDP is enabled. For more information, see Chapter 25, “Configuring CDP.”
• UDLD is disabled. For more information, see Chapter 24, “Configuring UDLD.”
• SPAN and RSPAN are disabled. For more information, see Chapter 27, “Configuring SPAN and
RSPAN.”
Note To use RSPAN, the switch must be running the LAN Base image.
• RMON is disabled. For more information, see Chapter 28, “Configuring RMON.”
• Syslog messages are enabled and appear on the console. For more information, see Chapter 29,
“Configuring System Message Logging.”
• SNMP is enabled (Version 1). For more information, see Chapter 30, “Configuring SNMP.”
• No ACLs are configured. For more information, see Chapter 31, “Configuring Network Security
with ACLs.”
• QoS is disabled. For more information, see Chapter 33, “Configuring QoS.”
• No EtherChannels are configured. For more information, see Chapter 38, “Configuring
EtherChannels and Link-State Tracking.”
Network Configuration Examples
This section provides network configuration concepts and includes examples of using the switch to
create dedicated network segments and interconnecting the segments through Fast Ethernet and Gigabit
Ethernet connections.
• “Design Concepts for Using the Switch” section on page 1-19
• “Small to Medium-Sized Network Using Catalyst 2960, 2960-S and 2960-C Switches” section on
page 1-24
• “Long-Distance, High-Bandwidth Transport Configuration” section on page 1-25
Design Concepts for Using the Switch
As your network users compete for network bandwidth, it takes longer to send and receive data. When
you configure your network, consider the bandwidth required by your network users and the relative
priority of the network applications that they use.
To Next Page
Loading...
