Cisco CATALYST 2960 User Manual

31-26
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
Chapter 31 Configuring Network Security with ACLs
Displaying IPv4 ACL Configuration
Displaying IPv4 ACL Configuration
You can display the ACLs that are configured on the switch, and you can display the ACLs that have
been applied to interfaces.
When you use the ip access-group interface configuration command to apply ACLs to a Layer 2
interface, you can display the access groups on the interface. You can also display the MAC ACLs
applied to a Layer 2 interface. You can use the privileged EXEC commands as described in Table 31-2
to display this information.
Table 31-2 Commands for Displaying Access Lists and Access Groups
Command Purpose
show access-lists [number | name] Display the contents of one or all current IP and MAC address access lists
or a specific access list (numbered or named).
show ip access-lists [number | name] Display the contents of all current IP access lists or a specific IP access list
(numbered or named).
show running-config [interface interface-id] Displays the contents of the configuration file for the switch or the
specified interface, including all configured MAC and IP access lists and
which access groups are applied to an interface.
show mac access-group [interface interface-id]
Displays MAC access lists applied to all Layer 2 interfaces or the specified
Layer 2 interface.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)