EasyManuals Logo

Cisco CATALYST 2960 User Manual

Cisco CATALYST 2960
980 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #536 background imageLoading...
Page #536 background image
20-12
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
Chapter 20 Configuring DHCP and IP Source Guard Features
Displaying DHCP Snooping Information
To stop using the database agent and binding files, use the no ip dhcp snooping database global
configuration command. To reset the timeout or delay values, use the ip dhcp snooping database
timeout seconds or the ip dhcp snooping database write-delay seconds global configuration
command.
To clear the statistics of the DHCP snooping binding database agent, use the clear ip dhcp snooping
database statistics privileged EXEC command. To renew the database, use the renew ip dhcp snooping
database privileged EXEC command.
To delete binding entries from the DHCP snooping binding database, use the no ip dhcp snooping
binding mac-address vlan vlan-id ip-address interface interface-id privileged EXEC command. Enter
this command for each entry that you want to delete.
Displaying DHCP Snooping Information
To display the DHCP snooping information, use the privileged EXEC commands in Table 20-2:
Note If DHCP snooping is enabled and an interface changes to the down state, the switch does not delete the
statically configured bindings.
Understanding IP Source Guard
Note To use the IP source guard feature, the switch must be running the LAN Base image.
Step 6
ip dhcp snooping binding mac-address
vlan vlan-id ip-address interface
interface-id expiry seconds
(Optional) Add binding entries to the DHCP snooping binding database.
The vlan-id range is from 1 to 4904. The seconds range is from
1 to 4294967295.
Enter this command for each entry that you add.
Note Use this command when you are testing or debugging the switch.
Step 7
show ip dhcp snooping database
[detail]
Display the status and statistics of the DHCP snooping binding database
agent.
Step 8
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Table 20-2 Commands for Displaying DHCP Information
Command Purpose
show ip dhcp snooping Displays the DHCP snooping configuration for a switch
show ip dhcp snooping binding Displays only the dynamically configured bindings in the DHCP snooping binding
database, also referred to as a binding table.
show ip dhcp snooping database Displays the DHCP snooping binding database status and statistics.
show ip dhcp snooping statistics Displays the DHCP snooping statistics in summary or detail form.

Table of Contents

Other manuals for Cisco CATALYST 2960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CATALYST 2960 and is the answer not in the manual?

Cisco CATALYST 2960 Specifications

General IconGeneral
ManageableYes
StackingNo
ModelCatalyst 2960 Series Switches
Power over Ethernet (PoE)Available on some models (IEEE 802.3af)
VLANs255 active VLANs
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Relative Humidity10% to 85% non-condensing
Power ConsumptionVaries by model (30W to 400W)

Related product manuals