Cisco CATALYST 2960

Index
IN-29
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
displaying the configuration 9-41
identifying the server 9-27
in clusters 6-15
limiting the services to the user 9-34
method list, defined 9-26
operation of 9-19
overview 9-18
server load balancing 9-40
suggested network environments 9-18
support for 1-12
tracking services accessed by user 9-35
RADIUS Change of Authorization 9-20
range
macro
12-19
of interfaces 12-18
rapid convergence 17-10
rapid per-VLAN spanning-tree plus
See rapid PVST+
rapid PVST+
described
16-10
IEEE 802.1Q trunking interoperability 16-11
instances supported 16-10
Rapid Spanning Tree Protocol
See RSTP
rcommand command
6-15
RCP
configuration files
downloading
A-17
overview A-16
preparing the server A-16
uploading A-18
image files
deleting old image
A-37
downloading A-35
preparing the server A-34
uploading A-37
readiness check
port-based authentication
configuring
10-38
described 10-17, 10-38
reconfirmation interval, VMPS, changing 13-27
reconfirming dynamic VLAN membership 13-27
recovery procedures 39-1
redirect URL 10-20, 10-21, 10-61
redundancy
EtherChannel
38-3
STP
backbone
16-8
multidrop backbone 18-5
path cost 13-22
port priority 13-20
redundant links and UplinkFast 18-15
reloading software 3-22
Remote Authentication Dial-In User Service
See RADIUS
Remote Copy Protocol
See RCP
Remote Network Monitoring
See RMON
Remote SPAN
See RSPAN
remote SPAN
27-3
report suppression, IGMP
described
21-6
disabling 21-16, 36-11
resequencing ACL entries 31-13
reserved addresses in DHCP pools 20-22
resetting a UDLD-shutdown interface 24-6
responder, IP SLAs
described
32-4
enabling 32-6
response time, measuring with IP SLAs 32-4
restricted VLAN
configuring
10-53
described 10-23
using with IEEE 802.1x 10-23
restricting access
overview
9-1