B-1
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
APPENDIX
B
Unsupported Commands in
Cisco IOS Release 15.0(1)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 2960, 2960-S, or 2960-C switch prompt but are not supported in this
release, either because they are not tested or because of switch hardware limitations. This is not a
complete list. These unsupported commands are listed by software feature and command mode:
• Access Control Lists, page B-2
• Boot Loader Commands, page B-2
• Embedded Syslog Manager, page B-2
• IGMP Snooping Commands, page B-3
• IGMP Snooping Commands, page B-3
• Interface Commands, page B-3
• MAC Address Commands, page B-3
• Miscellaneous, page B-5
• Network Address Translation (NAT) Commands, page B-5
• QoS, page B-6
• RADIUS, page B-6
• SNMP, page B-6
• SNMPv3, page B-7
• Spanning Tree, page B-7
• VLAN, page B-7
• VTP, page B-8
To Next Page
Loading...
