Configuring the PVC2300 and WVC2300 Cameras
Setup > Advance Setup
Cisco PVC2300 and WVC2300 Internet Video Cameras with Audio Administration Guide 69
8
When using a secure connection, video is not available. This option is used
only for configuration.
The port number must be specified in the URL when accessing the
camera’s web-based utility via the LAN or Internet. For example, if the
camera’s IP address is 192.168.1.99 and the port is defined as 1032, you
would specify the following address: https://192.168.1.99:1032.
RTP/RTSP
RTSP (Real Time Streaming Protocol) is a standard for connected client(s) to
control streaming data (MPEG-4) over the Internet.
RTP (Real-Time Transport Protocol) is an Internet protocol used for transmitting
single real-time multimedia data such as audio and video to a select group of
connected clients. RTSP uses RTP to format packets of multimedia content.
• RTSP Port—Enter the RTSP Port number (between 1024 to 65535) in the
field provided. The default RTSP port is 554.
• RTP Data Port—The camera’s data port number has been pre-configured
and can be used for multicasting. It does not normally need to be re-
configured. If a port number does need to be changed, please contact your
network administrator. If a change is necessary, enter the data port number
(1024 to 65535) in the field provided. The default RTP port is 5000.
• Max RTP Data Packet—Allows you to define the maximum size of the RTP
data packets. The length can be between 400 to 1400 bytes. The default
value is 1400 bytes.
• Enable Multicast—The camera’s video and audio IP addresses have been
pre-configured and can be used for multicasting. Normally these settings
do not need to be reconfigured. If an address does need to be changed,
contact your network administrator.
To Next Page
Loading...
