Cisco PVC2300 - MJPEG Settings; Mobile Settings; Video Adjustments

Configuring the PVC2300 and WVC2300 Cameras
Audio/Video > Video
Cisco PVC2300 and WVC2300 Internet Video Cameras with Audio Administration Guide 78
8
• Max Frame Rate—Select the desired maximum frame rate. The default
value is 30 fps.
MJPEG Settings
MJPEG (Motion JPEG) is a video codec where each video field (frame) is
separately compressed into a JPEG image.
• Resolution—Select the desired video resolution format. The default
resolution is 320x240.
• Fixed Quality—Select the desired fixed quality. The default is Normal.
• Max Frame Rate—Select the desired frame rate. The default value is 30
fps.
Mobile Settings
• Enable Mobile Streaming—Check the check box to enable streaming
video for the mobile devices.
- Resolution—The default resolution is 160x120.
- Video Quality Control—Choose from one of the following options:
- Constant Bit Rate — Select the desired constant bit rate. The default
value is 32 Kbps.
- Fixed Quality — Select the desired fixed quality. The default is
Normal.
- Max Frame Rate—Select the desired maximum frame rate. The default
value is 15 fps.
- Access Code—Entered at the end of a URL to access a live video
camera feed through another source, for example, a cell phone
connection:
rtsp://<IP Address>/access_code
Video Adjustments
• Power Line Frequency—Select the power line frequency (50Hz or 60Hz)
used in your region, to improve the picture quality under fluorescent lighting.