EasyManuals Logo

Cisco SPA 502G Administration Guide

Cisco SPA 502G
311 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
Provisioning Basics
Upgrading, Resyncing, and Rebooting Phones
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 146
6
Enter the upgrade command into your browser’s address bar to upgrade firmware
on a phone. Use the following syntax:
http://phone-ip-address/admin/upgrade?protocol://server-
name[:port]]/firmware-path
• Protocol defaults to TFTP.
• Server name is the host requesting the URL.
• Port is the port of the protocol being used (for example, 69 for TFTP or 80
for HTTP).
• Firmware-path defaults to /spa.bin (for example, http://192.168.2.217/
admin/upgrade?tftp://192.168.2.251/spa.bin) for SPA phones and /
wip310.img for the WIP310. The firmware-pathname is typically the file
name of the binary located in a directory on the TFTP or HTTP server.
Firmware Upgrade Parameters
The following table defines the function and usage of each parameter in the
Firmware Upgrade section of the
Provisioning
tab.
Parameter Description
Upgrade_Enable Enables firmware upgrade operations independently
of resync actions.
Defaults to Yes.
Upgrade_Error_Retry_Delay The upgrade retry interval (in seconds) applied in
case of upgrade failure. The device has a firmware
upgrade error timer that activates after a failed
firmware upgrade attempt. The timer is initialized with
the value in this parameter. The next firmware upgrade
attempt occurs when this timer counts down to zero.
The default is 3600 seconds.
Downgrade_Rev_Limit Enforces a lower limit on the acceptable version
number during a firmware upgrade or downgrade.
The device does not complete a firmware upgrade
operation unless the firmware version is greater than
or equal to this parameter.
The default is (empty).

Table of Contents

Other manuals for Cisco SPA 502G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SPA 502G and is the answer not in the manual?

Cisco SPA 502G Specifications

General IconGeneral
BrandCisco
ModelSPA 502G
CategoryIP Phone
LanguageEnglish

Related product manuals