Getting Started
Using the Web-Based Configuration Utility
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 16
1
Roadmap to Configuration Utility Features
The following tables provide a roadmap to features available in the configuration
utility.
To perform these tasks... In the configuration utility, click
the ...
View phone, extension, and line/call information,
including:
• DHCP, current IP address, DNS addresses
• Software and hardware versions
• Broadcast, RTP, and SIP information
• Registration state
• Packets sent, received, lost, and other
information
Info tab
See “Viewing Phone
Information” section on
page 19.
Configure system-level parameters, including
network and debug parameters. To:
• Enable the configuration utility and
administrator access
• Set the Internet connection type to DHCP
• Configure the syslog and debug servers
• Enable VLAN and CDP
System tab
See Chapter 5, “Configuring
Security, Quality, and Network
Features.”
Configure parameters to adjust SIP stack and
protocols. To enable:
• CTI
• SIP-B
• STUN
SIP tab
See Chapter 4, “Configuring
SIP, SPCP, and NAT.”