EasyManuals Logo

Cisco SPA 502G Administration Guide

Cisco SPA 502G
311 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #208 background imageLoading...
Page #208 background image
Configuring the Cisco SPA 500S Attendant Console
Setting Up the Cisco SPA 500S Attendant Console
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 196
9
STEP 5 In the BLF List URI field, enter the URI to generate BLF keys:
listname@domain.com;vid=2
Where:
listname: Name of the list.
domain.com: Name of the domain.
vid: Assigns keys to the extension. By default, the SUBSCRIBE is sent when
“Ext 1” is registered. You must set the “vid=” to a different value to change
this behavior.
For example:
mylist@broadsoft.com;vid=2
STEP 6 Click Submit All Changes.
Attendant Console Parameters
Parameters in the Attendant Console web page are described in the following
table. For information about Unit/Key syntax, see the previous sections.
.
Parameter Description
Subscribe Expires Specifies how long the subscription remains valid.
After the specified period of time, elapses, the Cisco
SPA 500S initiates a new subscription.
Defaults to 1800.
Subscribe Retry Interval Specifies the length of time to wait to try again if
subscription fails.
Unit 1 Enable Enables or disables the first Cisco SPA 500S unit (each
phone can have up to two Cisco SPA 500S units
attached).
Unit 2 Enable Enables or disables the second Cisco SPA 500S unit
(each phone can have up to two Cisco SPA 500S units
attached).
Subscribe Delay Length of delay before attempting to subscribe.
Defaults to 1.

Table of Contents

Other manuals for Cisco SPA 502G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SPA 502G and is the answer not in the manual?

Cisco SPA 502G Specifications

General IconGeneral
BrandCisco
ModelSPA 502G
CategoryIP Phone
LanguageEnglish

Related product manuals