- 56 -
(3) Status caused by an error (when n = 3 is specified)
Bit Status Hex. Decimal
0 Fixed 00 0
1 Fixed 02 2
No B.M detection error occurred
(only when B.M paper is selected)
00 0
2
A B.M detection error occurred
(only when B.M paper is selected)
04 4
Auto cutter error not occurred 00 0
3
Auto cutter error occurred 08 8
4 Fixed 10 16
Unrecoverable error not occurred 00 0
5
Unrecoverable error occurred 20 32
Auto recovery error not occurred 00 0
6
Auto recovery error occurred 40 64
7 Fixed 00 0
Bit 3: If this error occurred because of a paper jam, for example, remove the cause
of the error, and then DLE ENQ n (1 n 2) can be used to recover from the
error. However, it is not possible to recover from any error due to a circuit
problem (e.g., broken wire).
Bit 6: If a head overheat error is detected, the printing is stopped until the head
temperature falls. At this time, bit 6 = 1.
(4) Continuous paper detector status (When n = 4 is specified)
Bit Status Hex. Decimal
0 Fixed 00 0
1 Fixed 02 02
Paper found by Paper Near-end Sensor 00 0
2
Paper not found by Paper Near-end Sensor 04 4
Paper found by Paper Near-end Sensor 00 0
3
Paper not found by Paper Near-end Sensor 08 8
4 Fixed 10 16
Paper found by Paper-end Sensor 00 0
5
Paper not found by Paper-end Sensor 60 96
Paper found by Paper-end Sensor 00 0
6
Paper not found by Paper-end Sensor 40 64
7 Fixed 00 0
[See Also] Appendix 4.3 “Identification of Send Status”
DLE ENQ, ESC c 4, GS a, GS r
To Next Page
Loading...
