Claas ROLLANT 250 - Manual Overload of the Automatic Wrapping; Triggering Early Wrapping; Delaying the Wrapping Process

9.2.10 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Operation
Manual overload of the automatic wrapping
Triggering early wrapping
This process is used e.g. if there is not enough
material for the last bale at the end of the swath.
Early wrapping can be initiated by pressing pushbutton
(5) up to just before the start of automatic wrapping
(twine or net).
Delaying the wrapping process:
This method is applied if e.g. the end of the swath can
be reached by this delay.
Delayed wrapping can be initiated by pressing and
holding push button (6) up to just before the start of
automatic wrapping (twine or net).
Wrapping will then automatically start after releasing
pushbutton (6).
Note!
The fully filled baling chamber will force the
tailgate approx. 5 cm (1.9 in) open. This
actuates a switch, which then starts the
automatic wrapping operation.
If the wrapping process is not automatically started
when delaying the wrapping process, the baling
chamber is not yet completely filled.
In this case the baling chamber must be filled further or
the wrapping process must be triggered earlier.
(Fig. 13)
13