Claas ROLLANT 250 - Pick-Up in Float Position; up; Engage; Disengage Knives; Rotor Reverse

000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 10.1.5
Control Terminal
Pick-up in float position / up
(Fig. 1)
Engage / disengage knives
(Fig. 1)
Note!
If the voltage supply is interrupted both cutting
blades and hydraulic supply must be
reactivated.
Rotor reverse
(Fig. 1)
Pick-up in float position: Hold the key
depressed and release after the second
bleep. The pick-up is in float position.
Pick-up up: Press the key once to deacti-
vate the float position. Hold the key
depressed a second time, until the desired
position is reached.
Engage knives (cutting position)
Disengage knives
Press “Engage knives” and “Disengage
knives” simultaneously to start a rotor
reversing cycle.
Note!
The reverse rotation device can be
operated a maximum of 3 times.
Then the machine must rotate
forwards again.