000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 8.2.1
Setting up the baler
WRAPPING
Net wrapping
Only use original CLAAS Rollatex netting.
Attention!
The rubber-coated roller of the Rollatex
wrapping system may under no
circumstances come into contact with oil or
grease.
Note!
Keep spare rolls of netting in the packaging to
protect them from dirt.
We recommend that you apply talcum powder (CLAAS
ET-No. 241 756.0) to the rubber rollers as necessary.
Keep the brake shafts free of dirt and rust.
Inserting the net
Attention!
Only insert the netting when the tractor
engine is switched off and the ignition key
has been removed! Do not reach into the
casing – risk of injury from knife (M)!
1. Raise the net roll tightening clamp (X) and secure
it in its raised position.
2. Disengage the spare net roll holder at (E) and
swing it towards the front.
3. Push the net roll upwards into the net roll trough.
(Fig.1,2,3,4)
1
2
3
Setting up the baler
To Next Page
Loading...
