8.2.2 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Setting up the baler
Release the pressure roller by means of lever (H).
Disconnect the tension rods (T) and swing the
pressure roller back.
Raising the knife (M):
Danger!
Do not reach into the shaft - danger of injury
from the knife!
Before inserting the net, the knife must be raised to its
upper pretightened position.
This is done by opening the tailgate completely and
then closing it again, or by raising the straddling dowel
(G).
When the knife is in its raised position, the segment
must be located on the stop (L) behind the cam roller
(R).
(Fig. 4)
4
To Next Page
Loading...
