Group 25, Steering Column and Gear
25-3-4 • Steering Column and Component Removal and Replacement SM 765, Dec ’06
Steer Column and Component
Replacement
These steps cover the procedures for reinstallation of the
steering column including the steering gear, the tilt lock
assembly, directional control assembly, ignition switch,
and steering hand wheel and horn.
IMP
RTANTIMP
RTANT
Make sure all parts are clean and dry before
reassembling.
It may be necessary to assemble the steering
column in place and hand tighten fittings so
that the correct alignment of the entire col-
umn and parts can be checked. Once you
have the correct alignment, torque all fittings
to their correct specifications.
1. Component replacement and reassembly is in reverse
order of removal.
To Next Page
Loading...
