Group 34, Uprights
SM 765, Nov ’06 Upright Removal and Replacement • 34-8-3
3. Remove tilt cylinder rod-end lock plates and rod-end
pins from upright.
4. Remove trunnion ring bolts and lift upright off frame.
See illustration on page 1.
5. Slowly set upright down on the floor, 100 x 100 mm
(4 x 4 in) blocking, or sturdy pallets set end-to-end.
Upright Replacement
1. Use an overhead chain hoist of adequate capacity and
an approved lift chain to lift upright into position.
WARNING
!
Use prybars to move the assembly into posi-
tion for reattachment.
Tilt cylinder
Mounting
Tilt cylinder
mounting Bolt
Tilt cylinder
Rod end
To Next Page
Loading...
