EHX configuration /
Dynam-EC software
4.2 Backing up your EHX 7.x/8.x/9.0 configurations
4.3 Installing EHX and Dynam-EC Clients
4.4 Importing your configurations into EHX
5.4 Upgrading the CPU card application code
Dynam-EC is also installed as
part of the EHX/Dynam-EC
combined installer. This section
details how to install the Dynam-
EC client only on a machine i.e.
where only the dynamic online
matrix audio monitoring and
control is required.
FreeSpeak II Beltpack,
Antenna Transceiver
17 Upgrading FreeSpeak II™ wireless systems
1.9 and 2.4 FS II Beltpack
application only
Table 3-9: Procedures for upgrading from Eclipse HX v8.5.2 to Eclipse HX v9.1
3.10 Upgrading from 8.7
The following table lists the procedures that you will require to upgrade from Eclipse HX v8.7 to Eclipse HX v9.1.
Important note:
The table lists the procedures in the order in which they must be carried out. To go to a procedure, click the cross-reference / link.
To Next Page
Loading...
