4 Upgrading to Eclipse HX v9.1
This chapter describes the files you require to install Eclipse HX v9.1. It also describes
how to back up your ECS 5.2.5 configurations and import them into Eclipse HX v9.1
Important notes:
This guide is laid out in the order in which you must upgrade your Eclipse software and
hardware devices to Eclipse 9.0. For a quick reference to upgrading your system, see
3Quick reference: Upgrading to Eclipse HX.
4.1 Backing up your ECS v5.2.5 configurations
Back up your ECS v5.2.5 configurations by exporting them from ECS v5.2.5 to a hard
disk location. In ECS:
1) Open the configuration you wish to save.
2) Select File > Export Project.
3) Save the configuration to a location on your hard drive. The configuration will be
saved as a *.ccn file, which you can import later into EHX (the configuration
software for Eclipse HX v9.1).
Note: EHX can open *.ccn format files as well as its own *.hxn format configuration files.
Repeat the above procedure for all the configurations you want to save.
4.2 Backing up your EHX 7.x/8.x/9.0 configurations
Back up your EHX 7.x/8.x configurations by saving them to a secure location on your
hard drive.
1) Open the configuration you wish to save.
2) Select File > Save Project.
4.3 Installing EHX and Dynam-EC Clients
EHX is the configuration software for Eclipse HX v9.1. Dynam-EC is the application used
for online monitoring and dynamic audio routing.
The Eclipse HX v9.1 software USB contains a number of executable (*.exe) files for
installing EHX and Dynam-EC:
To Next Page
Loading...
