12 Upgrading E-DANTE64-HX cards
Upgrades for your E-DANTE64-HX card are available for both EHX and Dante firmware
and are available from your Clear-Com representative.
The upgrade process for each of the two modules on the card (EHX and Dante) is
different. The two processes are outlined below.
Note: When upgrading your E-Dante64 card, only use the Clear-Com supplied upgrade files for
both
(A: EHX) ClearCom - App, Boot, DSP, FPGA: xxxxxx.FWC files
(B: Dante) ClearCom [Brooklyn]: xxxxxx.dnt file.
To check if your firmware is up to date, open the Firmware Report
in EHX:
1) In the EHX software, navigate to the Layout tab.
2) Right click on the required matrix and select Firmware/Firmware Report.
12.1.1 Upgrade EHX E-DANTE64 firmware
1) In the EHX software, navigate to the Layout tab.
2) Right click on the matrix to be upgraded and select Firmware > Update
Firmware > Card.
3) Navigate to where the E-Dante64 upgrade file is stored and click to upload.
There are 4 possible upgrade file types.
To Next Page
Loading...
