16 Upgrading the AES-6 module
This chapter describes how to upgrade the application code of the AES-6 interface
module.
Before attempting any upgrade of the AES-6 card, ensure that anti static precautions are
taken, as the Eclipse HX devices are sensitive to static discharges.
Observe all electrical shock hazard warning and precautions for
handling electrostatic sensitive devices
Note:
This guide is laid out in the order in which you must upgrade your Eclipse HX software
and hardware devices. For a quick reference to upgrading your system, see 3Quick
reference: Upgrading to Eclipse HX.
To upgrade the AES-6 application code:
1. Ensure you have the following equipment:
A USB-to-serial adapter is usually acceptable.
CellCom / FreeSpeak
/ FreeSpeak II
(FSBP) registration
cable
PD4007Z, DB-9 to 3.5mm jack.
The appropriate AES-
6 application code file
(*.mot file)
The AES-6 application code (*.mot format file) is
available from the software USB:
Drivers USB > ECLIPSE DRIVERS >
Other_Software > xxxxxx - AES-6 Application
(where xxxxxx represents the product number)
Hitachi Renesas Flash
Development Toolkit
(FDT)
Third party software is available from either of the
Eclipse HX 9.0 upgrade media:
• Software USB > SOFTWARE - EHX.xxx >
3rd_Party_Software > Hitachi_FDT
• Drivers USB > ECLIPSE DRIVERS >
3rd_Party_Software > Hitachi_FDT
Tip: For more information about installing the Hitachi
Renesas FDT, see Appendix E:Hitachi Renesas
Flash Development Tool.
Table 16-1: Required equipment
To Next Page
Loading...
