Page 26 399G169 Rev B 27 April 2016
3.3.1 Setting standalone mode
1) Connect power to the antenna and at the same time press the black
Mode button on the base of the antenna. This puts the antenna in
standalone mode, and opens it for pairing to a beltpack.
Note: The amber LED flashes continuously to show that the antenna is open for
pairing with a beltpack in standalone mode.
2) Holding the beltpack, press the
Menu key (2 second press) and
navigate to
System Connect using the right hand rotary controller
on the beltpack.
3) Press button
D to see local systems available for connection.
Note: In menu mode the
D key on the beltpack operates as SELECT and the C key
exits the menu level and cancels the selection.
To Next Page
Loading...
Need help?
General
