Page 64 399G169 Rev B 27 April 2016
Your FreeSpeak II Base system arrives with default Roles which can be used
'as is'. The default setting puts all beltpacks and the Base headset into
Channel 1 and 2, where they talk and listen in a conference or Partyline set
up. Simply register the beltpacks to the Base and select the next available
Role when you power the beltpack on.
To use pre-defined Roles, simply select the next available Role for your
beltpack when it powers up.
Note: Beltpacks must be registered to the Base before a Role can be selected.
Note: The default Role can be changed to suit your requirements. It can also be
reset to factory settings.
8.3 Changing Channels on beltpacks
To change the Channel on a beltpack you will edit the Keyset of that
beltpack. This is the same basic process from both the CCM and the Base
Station. You will:
• Select the Role (the beltpack configuration map)
• Select the key to change
• Change the audio assignment on the key.
Change channels in the CCM:
To Next Page
Loading...
