EasyManua.ls Logo

Clear-Com FreeSpeak II - Base Station Rear Connector Pinouts

Clear-Com FreeSpeak II
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 13 399G169 Rev B 27 April 2016
Control
Description
J
2 x RJ45 ports. These can be used for network connection or for
daisy-chaining devices. Note: The ports share an IP address, so
only one network connection is possible (either port can be used).
K
GPIO connector.
Note: For connection between the Base and antenna/splitter and digital audio
feeds, Clear-Com recommends
shielded Cat 5/6 cable. Use of other cable
can result in shorter cable runs and other performance problems.
2.5 Base Station rear connector pinouts
2.5.1 DECT SYNC (connector E)
Pin
Sync In
Sync Out
Pin 1
DECTSYNC +
DECTSYNC +
Pin 2
DECTSYNC -
DECTSYNC -
Pin 3
8 KHZ+
8 KHZ+
Pin 6
8 KHZ-
8 KHZ-
2.5.2 Partyline (connectors F)
Pin
Pin 1
Pin 2
Pin 3

Table of Contents

Other manuals for Clear-Com FreeSpeak II

Related product manuals