Page 57 399G169 Rev B 27 April 2016
7.2 Master volume low level limiter (beltpacks)
7.2.1 About beltpack low level limit
This feature sets a low level limit in order to prevent beltpacks from being
turned down so low they cannot be heard.
How this feature is used depends on your preferred working practice: it is
possible to turn the volume on the beltpack down so low that all audio is
inaudible. This can cause confusion among the unwary, although some users
may want to turn the volume down completely on occasion.
Values: -6, -12, -21, -70 OFF. Default value = -70 OFF. If OFF, audio can
be turned down so low it cannot be heard at all.
7.2.2 Setting beltpack low level limit
The low level limiter feature is set in Roles, from the CCM, The Base Station
menus or from the beltpack itself.
• From the CCM
• From the Base Station menus.
To Next Page
Loading...
Need help?
General
