Page 42 399G169 Rev B 27 April 2016
6 Using Beltpacks
Beltpacks are always configured using Roles. For more information, see 8
Roles.
6.1 Registering Beltpacks
Wireless beltpacks must be registered to your Base Station before you can
use them with the antennas.
Roles must be available for beltpacks before you register them. Your system
arrives with default Roles which can be used, or you can create your own.
There are two ways of registering beltpacks:
• Registering beltpacks using USB cable
• Register beltpacks over-the-air (OTA).
Registering by USB cable is the quickest and easiest way.
6.1.1 Registering beltpacks using USB cable
You must have a USB A to micro USB B cable and the beltpacks to hand
before you start.
1) Connect a beltpack to the Base Station using a USB A to micro USB B
cable.
The beltpack can be powered on either before or after connection.
The Base Station will show 'Beltpack is now registered' in the front menu
screens.
2) Select an available Role from the beltpack screen.
To Next Page
Loading...
Need help?
General
